As long as the T-One # 118624 wiring isn't touching the heat shield it is in a good place on your 2015 Land Rover Evoque. I have attached an installation video of us installing this wiring kit on a 2013 Evoque that you can reference.
If you plan on using the Draw-Tite Max-Frame Trailer Hitch Receiver # 75227 for towing then to complete a towing setup you also need a ball mount kit. I recommend checking out Ball Mount Kit # 989900 because it includes two ball mounts, one with a 3/4” rise... view full answer...
Thank you for the information. The instructions might be better off saying that the connectors are usually on the passenger side but could be in an alternate location such as the driver side. This is not the first time I have heard of this. Subaru is actually notorious for moving the connection points to different locations. This is the first time I have heard of the issue on a Land Rover though.
Interestingly, the other harness for the 2012 Evoque, # C56159, just says behind the bumper... view full answer...
The connector you need to use to install the Tow Ready wiring harness part # 118624 on your 2012 Land Rover Evoque is under the vehicle on the passenger side. Locate the opening to the right of the vehicle muffler. You will reach up into the opening to find the great plug.
Check out the picture I attached to see the plug you are looking for. view full answer...
The Curt Trailer Hitch # C13128 does require the use of support straps with all non-trailer loads, such as bike racks. If support straps aren't use with this trailer hitch, it will void the product warranty.
You would want to support your bike rack with a support strap like the Curt Trailer Hitch Support Strap # 18050. view full answer...
We do have the Curt trailer hitch for the 2012 Range Rover Evoque, # C13128. There is no drilling required for installation but the exhaust will need to be temporarily lowered for installation and there is some minor fascia and heat shield trimming required. I have included a link to the installation instructions so you can see a little more detail on the trimming that is needed.
There are also some lovely pictures in the hitch instructions that show the finished result of the installation.... view full answer...
I spoke to my contact at Tekonsha and he said that the port for installing a brake controller on your 2013 Range Rover Land Rover Evoque is under the dash near the center console. He said that all models of your vehicle should have the port. My contact at Curt who also makes brake controllers confirmed the same thing.
I attached a video that shows how the # 3035-P harness will install in a similar vehicle. My contact at Tekonsha said that the port will be in the same place on your vehicle.... view full answer...
If it seems like the long M14-2 x 110 bolt used to install the Curt Hitch part # C13128 is too long and is topping out in your vehicle weldnut then most likely the problem is that you have a dirty weldnut that needs to be cleaned. If you check out the help article on cleaning weldnuts you will see ways to help get the threads back to normal so the bolt will thread all the way in.
I also attached an install for this hitch for you to check out as well. view full answer...